In a previous post I discussed my odd obsession for Winfield multiplier reels. I had a large bag of spare parts in a drawer which I have been meaning to investigate for a long time. Being on holiday now I had some time on my hands so I emptied out the bag and poked around to see if I could build a complete reel from the parts.
Because I am frequently messing about with old tackle I keep a tool box filled with the tools I need in the fishing room. There is nothing fancy in this box, just the usual range of screwdrivers, small spanners, punches and files but it is nice to have them all in one place so I know where everything is. The same goes for the assorted cleaning agents and lubricants.
There were a number of parts from old Bassfisher multipliers so I started cleaning them up and laid out all the good bits in order. One of the main drives was busted but the other one was in good condition after it was cleaned and greased. Frame parts were cleaned up using a bath of vinegar and scrubbed with an old toothbrush. I pepped up the vinegar by adding a couple of teaspoons of baking powder as this seems to speed up the process of removing the gunk. The cross bars had mostly shed their chrome finish but the brass underneath will cope with all I plan to use this old composite reel for. The end result, while far from perfect, is a serviceable reel.
Next, I attempted to make one reel from what appeared to be the parts of at least three different shore caster/surf casters. An end plate and drive had to be completely stripped and various parts replaced. The wrong screws had been used by someone in the past so that gave me a few headaches as I searched for the correct ones and cut down a couple of oversized screws to make up the balance. The drag didn’t work so that had to be taken apart and different washers fitted. The anti-reverse spring was missing but I had a spare so I popped that in.
There was no ratchet on the opposite end plate and this is a problem as the ratchet button is riveted in. I had a near complete end plate with a ratchet from a Surf caster and they are the same size so I used that instead. Once again, the finished reel was fully functional and will live in the back of the car as a spare in case of emergency. I will give them both a final lubrication and clean then spool some new line on to them in the morning.
Why bother? That’s probably what you are all thinking as you read this post. You can buy a cheap reel for a few Euro these days and i could have saved myself the hassle and cursing as I spent an afternoon messing about with the old bits of 1970’s reels. The thing is that I get enjoyment from little projects like this, making something useful from a pile of old junk.
The next day……………….
There was an elderly and much abused Woolworths levelwind reel in with the rest of my junk so I decided to try to resurrect this one too. There were obviously some parts missing and one end plate was badly cracked. The reel would barely turn and it emitted a horrible grinding noise when you did get the handle to turn. Removing the spool end float the cause of the noise became obvious. The cracked end plate had been allowing salt water directly into the bearing, causing the grease to emulsify and the bearing to dry out. The bearing was trashed.
The ‘bag of bits’ came to the rescue and I had a near complete end plate and bearing assembly which I could simply swap into place. Cosmetically it meant the reel now had one side black and the other green but I am guessing the fish won’t mind a jot.
Next I took a look at the drive and was horrified to see the previous owner had smathered the whole inside of the reel with thick red grease
(‘smather’ seems to be a west of Ireland word meaning to cover in excess). I needed lighter fuel and a bit of effort to remove the worst of this grease then I put the drive back together again.
The level wind itself was also chocked with thick grease and required stripping down and cleaning. When I finally got it cleaned I found damage to the shaft so that had to be binned. Once again, I had a spare which popped right into place. Re-assembly was straightforward and in a few minutes I had a perfectly functioning reel.